Mtroniks Marine15 'Plug n Play'
Click image above to enlarge
The Viper Marine15 'Plug n Play' is a Brushed Speed Control designed specifically for use in RC model boats.
The Plug n Play set up means ....... NO setup! The speed control learns as you use it and calibrates itself automatically to your transmitter!
There are no adjustable features on the Plug n Play speed control so nothing can get in your way of trouble free sailing straight from the packet!
The Marine15 has a 15Amp motor limit, what this means is that you can use any, DC Brushed motor, as long as the current drawn by that motor does not exceed 15Amps under load (with the prop connected, under water).
The Marine15 is the perfect speed controller for anybody wanting to either upgrade their old Speed Controller for a no nonsense 15Amp limit reversible electronic Speed Control or for anybody who uses scale model RC boats at scale speeds.
The Marine15 is the first in line in the Viper range of Speed Controls suited to RC model boats, which means it has all the features that you would expect on a more expensive Speed Control! Features such as a built in failsafe are standard on this entry level Speed Control and the motor stall protection is a feature which cannot be overlooked when a possible encouter with weeds is always a possibility.
A break down of the Viper Marine15 Plug n Play specification can be seen below
- NEW built in failsafe to protect against complete loss of signal or when out of range (compatible with all manufacturers receivers)**INDUSTRY FIRST**
- ABSOLUTE short circuit and motor overload protection
- 15Amp motor limit
- 1.2A BEC
- Dual core microprocessor
- 5 -10 cells input voltage (6.0-12.0V)
- 4 Layer super power circuit board
- Thermal integrated protection system
- Plug and Play set up - !! NO SET UP !!
- Legendary 100% waterproof design
- Dimensions : L39.0mm x W34.0mm x H13.0mm
- Weight : 55g
Set up hints and tips for the Viper marine range of controllers, FAQ
Q, When I switch on I get a solid red light?
A, Check that the speed controls receiver lead is plugged into channel 2, not the batttery slot.
Q, Motor runs at full speed reverse when pairing 2.4G transmitter and receiver?
A, On most 2.4G systems there is a built in failsafe that sets a position for the throttle during failsafe, with flight type transmitters this is generally full back stick. In a forwards and reverse application (model boat) this needs to be reset to mid stick point (Refer to transmitter manual). The speed controller will only do what it is told by the transmitter, ie, the speed controller does not know the reciever is in failsafe mode. It will recognise this signal as a valid signal and respond accordingly. The speed controllers internal failsafe operates if there is excessive noise or an invalid signal only.
Q, Throttle goes dead at the end of the stick travel after I set the controller to my transmitter?
A, This is due to the output range of the transmitter going beyond the range that the Viper will recognise. The solution is to set the E.P.A. (end point adjustment) to 70% on the throttle channel and then reset the speed controller. This situation is similar to a rudder which travels too far, you reduce the E.P.A. to 'tune' things to work over a suitable range. If your transmitter does not have adjustable E.P.A. please contact Mtroniks.
What are we doing about this? (Honest answer!) - The new 'tio' range of marine controllers adjusts this range automatically, we can't do this with the Viper controllers due to limitations in the processor memory.
| Plug and Play Instructions Marine15 Plug and Play instruction sheet |
Download now >>
|
