Mtroniks Marine MIRROR
Click image above to enlarge
The Viper Marine MIRROR is a Brushed Speed Control designed specifically for use in RC model boats where identical operation in both directions is required, for example a bow thruster!
The Marine MIRROR, 'Mirrors' the operation exactly about the neutral point of your transmitter. It also features the new Plug n Play set up which in effect means .... no set up!!! The Speed control learns as you use it and calibrates itself to your transmitter without you having to do anything!
The Marine MIRROR has a 25Amp motor limit, what this means is that you can use any, DC Brushed motor, as long as the current drawn by that motor does not exceed 25Amps under load (with the prop connected, under water).
The Marine MIRROR is suited to all RC model boats, which means it has all the features that you would expect on a more expensive Speed Control! Features such as a built in failsafe are standard on this Speed Control and the motor stall protection is a feature which cannot be overlooked when a possible encouter with weeds is always a possibility.
A break down of the Viper Marine MIRROR specification can be seen below
- NEW built in failsafe to protect against complete loss of signal or when out of range (compatible with all manufacturers receivers)**INDUSTRY FIRST**
- ABSOLUTE short circuit and motor overload protection
- 25Amp motor limit
- 1.2A BEC
- Dual core microprocessor
- 5 -10 cells input voltage (6.0-12.0V)
- Adjustable features include programmable reverse (including disable)
- 4 Layer super power circuit board
- Thermal integrated protection system
- Plug n Play set up ..... NO set up!!!
- Legendary 100% waterproof design
- Dimensions : L39.0mm x W34.0mm x H13.0mm
- Weight : 55g
Set up hints and tips for the Viper marine range of controllers, FAQ
Q, When I switch on I get a solid red light?
A, Check that the speed controls receiver lead is plugged into channel 2, not the batttery slot.
Q, Motor runs at full speed reverse when pairing 2.4G transmitter and receiver?
A, On most 2.4G systems there is a built in failsafe that sets a position for the throttle during failsafe, with flight type transmitters this is generally full back stick. In a forwards and reverse application (model boat) this needs to be reset to mid stick point (Refer to transmitter manual). The speed controller will only do what it is told by the transmitter, ie, the speed controller does not know the reciever is in failsafe mode. It will recognise this signal as a valid signal and respond accordingly. The speed controllers internal failsafe operates if there is excessive noise or an invalid signal only.
Q, Throttle goes dead at the end of the stick travel after I set the controller to my transmitter?
A, This is due to the output range of the transmitter going beyond the range that the Viper will recognise. The solution is to set the E.P.A. (end point adjustment) to 70% on the throttle channel and then reset the speed controller. This situation is similar to a rudder which travels too far, you reduce the E.P.A. to 'tune' things to work over a suitable range. If your transmitter does not have adjustable E.P.A. please contact Mtroniks.
What are we doing about this? (Honest answer!) - The new 'tio' range of marine controllers adjusts this range automatically, we can't do this with the Viper controllers due to limitations in the processor memory.
| Plug and Play Instruction Sheet Marine MIRROR instruction sheet |
Download now >>
|
