Mtroniks G2 Beast speed control - For use in 1/8 RC models
Click image above to enlarge
;)
;)
;)
;)
;)
;)
;)
G2 Speed controls set new standards in brushless performance and power!
The G2 complete re-design will show that brushless technology has just reached a new high!
The G2 Beast brushless speed control has been designed to use in 1/8 scale competition racing. It has been optimised to give the best possible performance and top speeds when used with high quality brushless motors. The design of the G2 Beast which is 100% waterproof and impact proof makes it first choice for fitting into any of the many new 1/8 electric kits that are now available.
The VERY small design of the speed control make it very easy to install almost anywhere on the chassis so you can get it right in behind the motor and keep those wires short, this helps to minimise losses and reduce any drop in performance that you would get from using long wires! The pre drilled base of the G2 Beast is part of the heatsink which means that when you screw the speed control to the metal chassis of the model as instructed in the installation guide you actually make the entire chassis part of the speed controls heatsink! This means that there is virtually no heat build up in the speed control so you get the ultimate in performance right until the end of the race! There is no need for a fan!
The new features and high performance components used to build the G2 is what makes the G2 Beast the most competitve speed control in its class today. This completely new speed control sets new levels is brushless speed-control technology.
The G2 Beast is the perfect controller to run in the wet, you have the perfect set up for running in all conditions! See pictures above of the G2 Beast combo being run in the pouring rain installed in the 1/8 H8E buggy courtesy of Dez Chand RRCi.
G2 Beast features
- Perfect sensorless drive
- New G2H - high performance heat dissipation power boards
- New G2 software increases power and top speeds
- 100% Waterproof
- Safety features including thermal cut off
- NiMH/NiCAD/LiPo Support
- Built in data logger (8 minutes maximum)*
- New adjustable features via included Mtroniks pit card - Very easy to use
- New high power brakes, fully adjustable
- New high power drag brakes, fully adjustable
- Reverse lock out
- Input voltage - 7.2 to 14.8V
- Motor limit (2S)- 3000kv
- Motor limit (4S) - 2100kv
- Small size - 42.0 x 27.0 x 23.0mm
- Weight - 66g (excluding wires)
G2 Beast ................ You choose the chassis and we will provide the winning speed control that will brush aside ALL the competition!
*Data logger requires a Windows PC and the optional Mtroniks pit software available seperately
| G2 Beast instruction manual Full set of installation and set up instructions |
Download now >>
|
by chris manning:
review G2 Beast
(April-15-10)
Write an online review and share your valued opinion with other website users.
